This is the final but necessary step to get printable files; setting the right parameters helps improve the printing.
¶ Parameters
- Plate to Slice: <All Plates> and <Current Plate> are available (pay attention to this parameter if there are more than two plates).
- All Plates: the models of multiple plates are divided by plate and processed separately to generate multiple slice files.
- Current Plate: only the models on the currently selected plate are processed to generate the slice file.
| All Plates | Current Plate |
|---|---|
 |
 |
Note: For multi-plate printing, pay attention to the plate selection; you may choose to slice only the selected plate.
-
Slice Name(optional): you may edit the name of the slice file here .
-
Layer Thickness: the thickness of each layer printed (models will be printed layer by layer). Slicing will be finer as layer thickness goes smaller, but it would take longer time to print.
-
Z-Compensation: if turned on, the accuracy of formation could improve, but some certain delicate details would be affected negatively.
-
Contour Compensation: to reduce dimensional expansion.
- Model Contour: compensate the overall contour of the models.
- Bottom Contour (Bottom-adhered Model) : affect the specified bottom layers of bottom-adhered models.
-
Anti-aliasing: if turned on, you could get a finer surface finish, but some delicate details (like those under 30 μm) might be affected negatively.
-
Fuzzing: three values available: 0, 2, 4. Fuzzing is off when set at 0. You could get a finer surface finishing as the fuzzing level goes higher, but some certain delicate details (like those under 30 μm) would be affected negatively.
-
Suction Cup Processing: suction cup processing can significantly minimize the suction effect, avoiding dents, waviness, and deformation, thus achieving a better surface finish. However, it may also dramatically increase the time required for slicing and printing. (only suction cups ≥ 10 mm³ can be detected.)
-
Adaptive Layer Thickness for Raft: when printing raft, increase the layer thickness adaptively according to the resin.
-
Sync to Cloud: if turned on, a backup of this file will be created and saved at Cloud.
¶ Update History
| Version | Date |
|---|---|
| 1.0 | 2026-10-26 |